This video shows how to remove the rear interior panel on the hatch of a Volkswagen Golf mk4. This will need to be removed to access the lock mechanism and r After that, the easiest way to get the panel back on is to remove the felt window strip from the panel by pulling it down away from the door panel. It slides off pretty easy. Going back to the picture from step 3 you can see it as the dark strip at the top. here it re-installed on the door:
How to DIY Remove take off door panel 4th Generation F-Body Pontiac Trans-Am Trans Am and Chevrolet CamaroWhere to buy tiny door lock light bulb Sylvania 272
Take a small standard screwdriver and pry the center pin of the fastener out about 1/4 inch and you should be able to remove them. when replacing, insert the fastener through the holes and press the center pin in. 12-20-2012, 02:25 PM. # 3. revolutiongolfcars.com. Location: Golf Car Capital of The World
Figure 4 A Pillar Upper: Remove the center section by gently prying the top of the piece away from the door frame with your trim removal tool (red arrow). When reinstalling make sure to place the trim piece behind the weather seal on the door frame.
Remove the upper and rear trim pieces by the rear door opening and then each of the rear D pillars un-snap. The main side molding will have one scre about mid length under the carpet, and it tucks under the rear door sill as well. Other than that it all just unsnaps in about 4-5 places.
In this video I show the steps to removing a mirror, troubleshooting a problem, and re-installing the mirror, door panel, etc. It's a long, but detailed vid
Pull the door handle out first and hold it in the open position. Then begin loosening the internal screw. Loosen the screw until the lock is released. DO NOT remove the screw entirely. 7. After the lock has been released, continue holding the handle in the open position while pulling the lock barrel out of the door. 7oz4.
